Assemble Shaft Seal And Spool/Sleeve Set To Housing - Danfoss VSPP Service Manual

Service Manual
VSPP Steering unit
VSPP assembly

Assemble shaft seal and spool/sleeve set to housing

© Danfoss | November 2019
To assemble shaft seal and spool/sleeve set with springs, cross pin, ring and bearing assembly to the
housing, follow these steps.
1. Place the steering unit housing with the port face down on the work bench. Guide the outer part of
the assembly tool for shaft seal into the bore of housing (2) for the spool/sleeve set (1).
VSPP with guide for shaft seal.
2. Grease the new shaft seal (Roto Glyd. 7) with hydraulic oil and place them on the tool.
Ensure that the Roto Glyd seal is placed on the insertion tool as per the photograph.
Place the Roto Glyd seal on the insertion tool
AX319758618681en-000101 | 23