Sinclair SDV5 Series Service Manual page 32

Table 4-1.4: Spot check display table (for all model)
DSP1 content
0.--
1.--
2.--
3.--
4.--
5.--
6.--
7.--
8.--
9.--
10.--
11.--
12.--
13.--
14.--
15.--
16.--
17.--
18.--
19.--
20.--
21.--
22.--
23.--
Notes:
1. Operating mode:

0: standby; 2: cooling; 3: heating; 4: forced cooling.
2. The fan speed index is related to the fan speed in rpm and can take any integer value in the range 0 (0-off) to 8 (fastest).
3. Priority mode:

0: first ON priority; 1: cooling priority; 2: Automatic selection of priority mode; 3: heating only; 4: cooling only; 5: heating priority
Parameters displayed on DSP2
Operating frequency
Operating mode
Operating fan speed level
Total capacity requirement of indoor units
Total capacity requirement for the modified ODU
T3 Condenser temperature(°C)
T4 Outdoor ambient temperature(°C)
TP discharge temperature(°C)
TF invert module Temperature(°C)
TL refrigerant cooling tube temperature (°C)
EXVA position
Actual current (A)
Inverter compressor current (A)
Actual voltage (V)
DC bus voltage (V)
Indoor heat exchanger pipe (T2/T2B) average temperature (°C)
Total number of IDUs
Number of Operating IDUs
Model
System address
Priority mode
Version of the program
Most recent error or protection code
Display "--"
Remarks
Actual value = value displayed
Refer to Note 1
Refer to Note 2
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed× 8
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
Actual value = value displayed
ODU address in the centralized
control system
Refer to Note 3
"nn" is displayed if no error or
protection events have occurred
since start-up
31