Alarm Output Connection; Power On Device - HIKVISION DS-MP3516-RH Quick Start Manual

2.3 Alarm Output Connection

Follow the figure bellow to wire alarm output.
n and n# are a pair of alarm output. You can connect them with a relay alarm device. When the
voltage of connected alarm device exceeds the valid alarm output range, you need to connect a
relay to protect alarm output.
n
Relay
Output
n#
Alarm Powered by Direct Current

2.4 Power on Device

Connect to power supply after all the above installations are finished.
You can view the indicators to get knowledge about the device status.
 Power indicator (PWR):
 Solid green: Device is powered on.
 Solid red: Device is standby.
 Camera indicator (IPC):
 Flashing green: Camera is connected and data are transmitted.
 Unlit: Camera is offline. Check power supply and wiring.
 Recording indicator (REC):
 Solid green: Device is recording normally.
 Network interface indicator (G):
 Flashing green: Network transmission is normal.
 Unlit: No network. Check network cable connection and IP address.
 HDD indicator (HDD):
 Solid green: HDD is working normally.
 Unlit: No HDD. Check HDD installation.
 Alarm indicator (ALM):
Digital Video Recorder Quick Start Guide
Load
Relay
Output
Figure 2-4 Alarm Output Connection
GND Power
Output
n#
n
Alarm Powered by Alternating Current
JQC-3FG
Relay
(10 A/250 VAC)
~ 220 VAC
Live Neutral