Mobile Digital Video Recorder User Manual TABLE OF CONTENTS Chapter 1 Panel Introduction ................................8 1.1 Front Panel ....................................8 1.2 Rear Panel ....................................9 Chapter 2 Installation and Connections ............................10 2.1 Install SIM Card ..................................10 2.2 Install SD Card ..................................12 2.3 Power Cord Wiring ..................................
Page 3
INDIRECT DAMAGES, INCLUDING, AMONG OTHERS, DAMAGES FOR LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, OR LOSS OF DATA OR DOCUMENTATION, IN CONNECTION WITH THE USE OF THIS PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. REGARDING TO THE PRODUCT WITH INTERNET ACCESS, THE USE OF PRODUCT SHALL BE WHOLLY AT YOUR OWN RISKS.
Page 4
Mobile Digital Video Recorder User Manual Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Page 5
Mobile Digital Video Recorder User Manual autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.
Page 6
Mobile Digital Video Recorder User Manual Applicable Models This manual is applicable to DS-MP3504-SD series MDVR. Symbol Conventions The symbols that may be found in this document are defined as follows. Symbol Description Provides additional information to emphasize or supplement important points of the main text.
Page 7
Mobile Digital Video Recorder User Manual Safety Instructions Proper configuration of all passwords and other security settings is the responsibility of the installer and/or end-user. In the use of the product, you must be in strict compliance with the electrical safety regulations of the nation and region.
Mobile Digital Video Recorder User Manual Chapter 1 Panel Introduction 1.1 Front Panel Figure 1-1 Front Panel Table 1-1 Interface Description Name Description SD1&SD2 Two SD card slots. OFF/ON Power switch. POWER Power indicator: Light in green after device starts up; light in red when standby mode.
Mobile Digital Video Recorder User Manual Chapter 2 Installation and Connections Product pictures in following chapters are for reference only. In the event of any conflicts between this manual and the product, the later prevails. 2.1 Install SIM Card Purpose: Pluggable 3G/4G wireless communication module is designed for the device and you should install the SIM card to realize the wireless communication function.
Page 11
Mobile Digital Video Recorder User Manual Figure 2-2 Pull out SIM Card Tray Step 4 Place the SIM card on SIM card tray. Figure 2-3 Place SIM card on SIM Card Tray Step 5 Insert the SIM card tray back to SIM card slot. Figure 2-4 Insert SIM Card Tray back to SIM Card Slot...
Mobile Digital Video Recorder User Manual Step 6 Install the 3G/4G module back to the device and tighten the set screw. 2.2 Install SD Card Before You Start Prepare the tools and components for installation: Key to front panel (delivered with device) ...
Page 13
Mobile Digital Video Recorder User Manual Step 1 Connect the "DC IN +" of the device to the positive pole of automobile batteries, jumping over the switch of normal automobile power. Step 2 Connect the "DC IN -" of the device to the negative pole of automobile batteries. Step 3 Connect the "ACC"...
Mobile Digital Video Recorder User Manual Please contact the automobile manufacturer for the connection information of starting switch. The automobile ignition switch, also called car key, controls the startup and shutdown of your automobile. Most of automobiles adopt positive pole ignition switch currently. ...
Mobile Digital Video Recorder User Manual Device Automobile Power System DC IN Wiring of Device Point of Connection Automobile Power Switch Positive Pole Negative Pole Automobile Battery Figure 2-9 Scheduled Shutdown 2.4 Alarm Input/Output Connection 2.4.1 Alarm Input Connection The device adopts the high/low-level electrical signals triggering (high level: 6 to 36 VDC; low level: 0 to 5 VDC) to realize alarm input.
Mobile Digital Video Recorder User Manual GND Power JQC-3FG Output Relay (10 A/250 VAC) Load Relay Relay ~ 220 VAC Output Output Live Neutral Alarm Powered by Direct Current Alarm Powered by Alternating Current Figure 2-11 Alarm Output Connection 2.5 Sensor-in Wiring Step 1 Connect the delivered extension cable to I/O interface.
Page 17
Mobile Digital Video Recorder User Manual UD10195B...
Need help?
Do you have a question about the DS-MP3504-SD Series and is the answer not in the manual?
Questions and answers