Geokon GeoNet 8900 Series Installing page 39

Connecting Sensors to Nodes:
Bare Leads (Continued)
Wire each conductor into the terminal block by pressing down
3.
on an orange tab, inserting the bare end of the conductor into
the terminal block, and then releasing the tab
Conductors are wired as follows:
Vibrating Wire Sensors
RED =
BLACK = VW–
GREEN = TH–
To prevent possible short circuits, do not allow bare leads to
touch each other during or after wiring; trim long leads if
necessary
Addressable (RS-485) Sensors
GREEN = 485–
RED = 12V
BLACK = GND