Table of Contents
Advertisement
5.1.5 Discharge Cross Installation
The following procedure is used to install the discharge cross on the MP-16.
Place the new discharge cross into position
1
and bolt to secure to the discharge manifold
and cross support.
Reattach the Pressure Relief Valve, Pulsation
2
Dampener and other components to the
discharge cross.
5.1.6 Installing the Liner Wash System
Drop the liner spray manifold over the piston
assemblies and slide at the bottom of the
chamber. The hose may be connected at either
side.
weatherford.com
Pump and Fluid Systems
Chapter 5: Assembly/Disassembly
60
MP-16 2-Piece 5000 psi January 2013
Advertisement
Table of Contents
