Table of Contents
Advertisement
5.1.4 Installing the Fluid Modules & Manifolds
The following procedures should be used to install the fluid modules onto the pump.
The suction and discharge modules are weighty pieces of hardened
metal designed to withstand intense pressures, and can cause serious
WARNING
injury if dropped. Be sure that each module is sufficiently supported
before hoisting and beginning installation procedures.
Slide the discharge modules into position on
1
the pump frame. Care should be taken to
ensure that the threads on the studs are not
damaged.
Install the nuts on the studs and partially
2
tighten the discharge modules into position
on the power frame. Some adjustment may
be necessary to install the bearing retainer
flange.
weatherford.com
Pump and Fluid Systems
Chapter 5: Assembly/Disassembly
57
MP-16 2-Piece 5000 psi January 2013
Advertisement
Table of Contents
