10.4 Installation
−
Install the thermostat about 1.5 m (59") above the floor. In the event that the controller is intended for use by wheelchair
users, please refer to local regulations
Make sure the device is powered off prior to installation/service
−
−
Do not install in locations that can be affected by radiant heat or in places with high levels of sunlight
Do not install thermostats behind doors or in corners
−
−
Protect from water/debris to avoid damaging the Thermostat
10.5 Mounting
Insert a 3.5 mm flat
head screwdriver
1
along the bevel into
the slot.
Pry upwards with
appropriate force to
release the two
hooks
Connect the wires
3
according to the
appropriate wiring
diagram shown
above. Ensure the
polarity of the mains
supply is correct.
Fit the display module onto the base module.
5
Align upper hooks between the two modules.
Carefully replace the wiring connection if it has
been removed.
Click display module onto base module using the
two lower hooks.
10.6 Wiring
Provide an approved disconnecting means and overcurrent protection to supply conductors. The disconnecting device(s) shall meet
the relevant requirements of IEC 60947-1 and IEC 60947-3 and shall be suitable for the application.
Locate and mark per local requirements.
2
Remove the display
from the base module.
Carefully remove the
wire connections, if
required.
4
Mount the base
module onto the wall
box using the two
screws supplied.
25