Advertisement
Table of Contents
SOMFY INSTRUCTIONS
EOLIS 3D WIREFREE™
RTS WIND SENSORS
Part #'s
1816081 Eolis 3D WireFree
RTS Wind Sensor (white)
™
1816082 Eolis 3D WireFree
RTS Wind Sensor (off white)
™
1816083 Eolis 3D WireFree
RTS Wind Sensor (black)
™
The Eolis 3D WireFree RTS wind sensor detects horizontal,
vertical, and lateral movements. When preset threshold
is exceeded, awnings retract.
BEFORE YOU BEGIN
1. Make sure the "DOWN" button on
the remote extends the awning.
2. Clear awning of any debris and make
sure surface of awning is clean.
ADDING BATTERIES
1. Remove the sensor housing using a
small screwdriver.
© Copyright Somfy Systems, Inc. 7/2009
Sensor
Housing
Mounting
Plate
3. Apply tape and
secure mounting
plate to front bar
of awning.
Eolis 3D
2. Install 2AAA alkaline batteries (included).
Make sure the red light blinks. If red light does
not blink, check batteries for correct polarity.
C - 0004
Sensor Cover
Waterproof
Silicon Seal
Sensor
Electronics
Red
Light
Awning
Awning
Front Bar
PAGE1 REV 1
Advertisement
Table of Contents
Related Manuals for SOMFY Eolis 3D WireFree 1816081
Summary of Contents for SOMFY Eolis 3D WireFree 1816081
- Page 1 1. Remove the sensor housing using a 2. Install 2AAA alkaline batteries (included). small screwdriver. Make sure the red light blinks. If red light does not blink, check batteries for correct polarity. Light © Copyright Somfy Systems, Inc. 7/2009 PAGE1 REV 1 C - 0004...
- Page 2 5 seconds and test it again. (second test mode). NOTE: IF PROFESSIONAL PROGRAMMING ASSISTANCE IS REQUIRED. PLEASE CONTACT SOMFY AT somfytech@somfy.com OR YOUR LOCAL DEALER AT www.somfysystems.com/locatedealer. © Copyright SOMFY SYSTEMS, INC. 7/2009 PAGE2 REV1...
Need help?
Do you have a question about the Eolis 3D WireFree 1816081 and is the answer not in the manual?
Questions and answers