SOMFY 6301051 Installation Instructions

24V SOLIRIS RTS SENSOR KIT
CAT NO. 6301051
(includes transformer, not shown)
1
Installation
Sun Sensor Wind Sensor
2
Wiring
WARNING: For the SOLIRIS RTS SENSOR
the transmitter which is memorized into the motor's receiver,
must be configured correctly. The DOWN button MUST correspond
to DOWN on the end product. In the case of an awning, it will open
or extend the awning. If the UP button extends the awning, the
wind sensor will also extend the awning during windy conditions.
THIS IS DANGEROUS! Damage and injury could occur. Do not
proceed until proper operation of the transmitter is verified. Please
refer to the installation instructions of the relevant motor to change
the direction if necessary.
A. Power input to the sensor is not polarized,
but turn off the power and fully discharge
the transformer before making final connections.
B. The cable distance between the power supply
and the sensor must not exceed 164 feet.
TO 24V AC/DC
TRANSFORMER
SOMFY SYSTEMS, INC. reserves the
right to update, change or modify
these instructions without prior notice.
REF. NO: 182449A
COPYRIGHT C SOMFY SYSTEMS, INC.
inteo
SOLIRIS RTS

Installation Instructions

The SOLIRIS RTS
The wind and sun thresholds can be set directly on the
The SOLIRIS RTS
Power supply :
Rated Current :
The SOLIRIS RTS
Operating temperature :
to function properly,
3. Connect the cable leads to the terminals
- Terminal block is removable for easier
connections, and the input power is
not polarized.
SOMFY MEXICO S.A. De C.V.
Calle 3 No. 47, Loc. E-5
Fracc Ind. Alce Blanco
Nau., Edo. de Mex C.P . 53370
4/02
sensor is a radio sun & wind sensor for awnings.
sensor is compatible with the
24V AC/DC
25 mA at 24V DC
sensor must be supplied by a class 2 transformer
0 0
-4 F to 122 F/ -20
1. Remove Cover and unscrew
plate over wiring compartment
UP
STOP
DOWN
x
4. Replace wire
compartment cover
SOMFY SYSTEMS, INC.
47 Commerce Drive
Cranbury, NJ 08512
sensor 24V
SOLIRIS RTS sensor
LT RTS CMO and ALTUS RTS
0 0
C to +50 C
Dimensions
2. Loosen the strain relief
plate and guide the power
supply wires through
the black grommet into
terminal block.
strain
relief
TO 24V AC/DC
TRANSFORMER
x
5. Attach the sensor to the wall.
Replace front cover and secure
with screws provided
SOMFY CANADA
6315 Shawson Drive, Unit #1
Mississauga, Ontario L5T1J2
.
motors only.
9.3 in./236 mm
grommets