Samson TROVIS I/O Quick Manual page 8

Installation
Rail mounting
1. Fasten the spring-loaded hook (5) at the bottom of the top hat rail (3).
2. Slightly push the TROVIS I/O module upwards and pull the top hook (5) over the top hat
rail.
3. Undo the two screws (1).
4. Pull apart the electronics housing and the back panel.
5. Perform electric wiring on the back panel as described in section 4.2.
6. Place on the electronics housing.
7. Tighten the two screws (1).
8 KA 5500-Z EN