Adjusting The Rear Wheels - Kubota L2501 Operator's Manual

TIRES, WHEELS, AND BALLAST
Tire
15-19.5
Industry
(A) 1145 mm (45.1 in.)
13.6-16
Turf
(A) 1115 mm (43.9 in.)
11.2-24
Farm
(A) 1115 mm
(43.9 in.)

2.1 Adjusting the rear wheels

This section describe the procedure to change the
width of the rear tread.
WARNING
To avoid personal injury or death:
• Before jacking up the tractor, park it on a firm
and level ground and chock the rear wheels.
• Fix the front axle to keep it from pivoting.
• Select the jacks that withstand the machine
weight and set them up as shown in the
following figure.
68
Tread
(A) 1195 mm (A) 1290 mm
(47.1 in.) (50.8 in.)
(1) Jack point
1. Remove the bolts which mount the wheel rim and /
or disk.
2. Change the position of the rim and / or disk (right
and left) to the desired position.
3. Tighten the bolts.
IMPORTANT :
• Always attach the tires as shown in the
following figure.
• If you do not attach the rear wheel as the
following figure, transmission parts may be
damaged.
• Do not turn the rear discs to obtain the wider
tread.
• When re-fitting or adjusting a wheel, tighten
the bolts to the following torques.
(1) Bolt
Bolt (1) Tightening torque
Then recheck after driving the tractor as
follows, and
SERVICE INTERVALS on page 71.
200 m (200 yards) and 10 times of shuttle
Driving tractor
movement by 5 m (5 yards)
WHEEL ADJUSTMENT
215 N⋅m
(22 kgf⋅m)
[160 ft⋅lbs]
thereafter according
L2501
to