Mode2 ＊ Only Akw1111 (400Vac Applicable Type) - Panasonic KW1M Eco-Power METER User Manual

Preset value setting mode
Enter preset value to output using <ITEM/△><SHIFT/▽>.
Electricity charge setting mode
Enter the rate per 1kWh using
<ITEM/△><SHIFT/▽>.
4.3.2 MODE2
＊ Only AKW1111 (400VAC applicable type)
(Mode for setting of each parameter for pulse measurement)
Max. counting speed setting mode
Mode defines max. counting speed.
・Select from 2kHz/30Hz
Pre-scale setting mode
Mode defines pre-scale value used for changing count value.
・It can be set the range of 0.001 to 100.000. (Initial 1.000)
・The position of decimal point set with this mode is applied to count value and preset value.
ex) When 0.01 (Last 2-digit) is set, the decimal point of count value and preset value has 2 digit
under decimal point.
Mode2 Setting flow chart
Max. counting speed setting mode
Press <ITEM/△><SHIFT/▽> to change max counting speed.
Max. counting speed is selected from 2000(2kHz) ⇔ 30（30Hz）.
Pre-scale setting mode
Enter pre-scale value using <ITEM/△><SHIFT/▽>.
( 0 ～ 999999)
*It is only when "Cnt" is selected on unit for pulse output
setting mode.
→
(0.00～99.99
<SET>
Initial: 10.00)
Hz
PSCL
2000(2kHz)
(0.001～100.000, initial 1.000)
＊The decimal point
mode is applied to count value and
preset value.
Conversion factor setting mode
Enter the conversion factor per 1kWh
using <ITEM/△><SHIFT/▽>.
Monitor
↓ <MODE> (MODE 2 Lighting)
↓ <SET>
30(30Hz)
→
set with this
<SET>
17
KW1M Eco－POWER METER
(0.000～9.999
Initial: 0.410)
↓ <SET>
Monitor
Monitor
→
<SET>
→
<SET>