Burlink (Optional) - Burmester 061 Owner's Manual

Connecting to the BURLINK interface can be done either with the 9 pin D-SUB connector (RS-232) or with the USB
2.0 connector.
RS-232 configuration: 9600Baud, 8bit, parity: none, 1 stop bit, no hardware handshake
A USB device driver needs to be installed when using the USB 2.0 connector. System requirements for using the
USB software are either WINDOWS 2000 or WINDOWS XP operating system.
Following are listed the possible commands to control the CD player 061. All commands needs to be sent in capital
letters finished with a "carriage return" \r .
POWON\r
POWOFF\r
PLAY\r
PAUSE\r
STOP\r
SKIPFW\r
SKIPBW\r
FORW\r
BACKW\r
KEY0 to KEY9\r
REPEAT\r
CLEAR\r
AUDIO\r
AUDIO96\r
AUDIO192\r
DMODE\r
INP+\r
INP-\r
DIM0\r
DIM1\r
DIM2\r
DIM3\r
DIM\r
TYPE\r
VERSION\r
BURLINK
(optional)
CONNECTIONS
COMMANDS
switches the unit on
switches the unit to standby mode
starts playback of the CD
pauses playback of the CD
stops playback of the CD
skips forward to the following tracks
skips backward to the beginning of the current and previous tracks
starts search forward (two steps: slow/fast)
starts search backward (two steps: slow/fast)
for direct track selection
switches on the repeat modes (Track, Disc) or off
deletes a favorite track selection program
switches between a sample rate of 96kHz and 192kHz
switches to a sample rate of 96kHz
switches to a sample rate of 192kHz
switches the time display
switches the inputs of the CD player
switches the inputs of the CD player
switches the display brightness to maximum
switches the display brightness to middle
switches the display brightness to low
switches the display to off mode
switches the brightness step by step (0,1,2,3,0,1,2....)
shows the type of the unit
shows the software version of the unit
12