Power Off The Firewall; Power Off The Device At The Cli - Cisco Firepower 1100 Started Manual

Firepower Threat Defense Deployment with FDM
firepower#

Power Off the Firewall

It's important that you shut down your system properly. Simply unplugging the power or pressing the power
switch can cause serious file system damage. Remember that there are many processes running in the
background all the time, and unplugging or shutting off the power does not allow the graceful shutdown of
your Firepower system.
You can power off the firewall using FDM, or you can use the FXOS CLI.
Power Off the Firewall Using FDM
You can shut down your system properly using FDM.
Procedure
Step 1 Use FDM to shut down the firewall.
Note
a) Click Device, then click the System Settings > Reboot/Shutdown link.
b) Click Shut Down.
Step 2 Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit).
Step 3
After the chassis has successfully powered off, you can then unplug the power to physically remove power
from the chassis if necessary.

Power Off the Device at the CLI

You can use the FXOS CLI to safely shut down the system and power off the device. You access the CLI by
connecting to the console port; see
Procedure
Step 1 In the FXOS CLI, connect to local-mgmt:
firepower # connect local-mgmt
Step 2
Issue the shutdown command:
firepower(local-mgmt) # shutdown
Example:
For 6.4 and earlier, enter the shutdown command at the FDM CLI.
Access the FTD and FXOS CLI, on page 81.
Cisco Firepower 1100 Getting Started Guide
Power Off the Firewall
83