Table of Contents
Advertisement
Configure the DHCP Server
f) Click OK.
Step 5
Click Save.
Configure the DHCP Server
Enable the DHCP server if you want clients to use DHCP to obtain IP addresses from the FTD.
Procedure
Step 1
Choose Devices > Device Management, and click the Edit ( ) for the device.
Step 2
Choose DHCP > DHCP Server.
Step 3
On the Server page, click Add, and configure the following options:
• Interface—Choose the interface from the drop-down list.
• Address Pool—Set the range of IP addresses from lowest to highest that are used by the DHCP server.
• Enable DHCP Server—Enable the DHCP server on the selected interface.
Step 4
Click OK.
Step 5
Click Save.
Cisco Firepower 1100 Getting Started Guide
136
• IPv6—Check the Autoconfiguration check box for stateless autoconfiguration.
The range of IP addresses must be on the same subnet as the selected interface and cannot include the
IP address of the interface itself.
Firepower Threat Defense Deployment with a Remote FMC
Hide quick links:
Advertisement
Table of Contents
