2.3.6
Frame base unit
(1)
Remove the paper feeder. (See 2.3.1.)
(2) Remove the cover assy upper. (See 2.3.2.)
(3) Remove the cover assy top. (See 2.3.4.)
(4) Remove the high voltage power supply 1/ sensor board. (See 2.3.5.)
(5) Remove three screws
(6) Remove the screw
(7) Remove the inlet
the inlet
from the frame base
a flathead screwdriver from the side face of the frame base.
(8) Remove six cables
(9) Remove the screw
43641601TH Rev.1
.
and then remove the cable
of the low voltage power supply board from the frame base
, unlock the latch of the inlet
and disengage two engaging parts, and then remove the frame base
and then remove the LED panel board
Oki Data CONFIDENTIAL
and the contact CB
.
from the frame base
.
. When removing
, using
.
23 /