Advertisement
9. Connect the provided power
t-harness according to the diagram
displayed under Test Connection
at the bottom of page 5 or see
illustration on the right. Connect
the female and male 12V power
connectors first then route the
type-c connector to the designated
slot created during the preparation
steps on page 6.
10. Route the Type-C connector through
the pocket's hole (A), created during
the preparation step, then pass it
through the HAQ03 bezel (B).
Notes:
• Hide any excess wiring under the panels
before reassembling.
• Use the provided two-sided adhesives to
secure the panel/module from moving.
11. Connect the Type-C connector to
the MQUSM if not already done so.
Notes:
• Hide any excess wiring under the panels
before reassembling.
• Use the provided two-sided adhesives to
secure the panel/module from moving.
12. Lastly, reassemble everything in
reverse order, then place your Qi
enabled device onto the HAQ03
assembly to charge your device.
Refer to LED Charging Status for
charging details (page 5).
*Phone NOT included
VEHICLE ASSEMBLY
@-------
@r---����,..,
�
\!_!e,----""'-,..-��,-�!'!""-"'I
7
Female Connector to
12V harness connector
Male Connector to
Back of 12V Socket
(MQUSM)
Advertisement
