Download Print this page
Scosche HA1573 Installation Manual

Scosche HA1573 Installation Manual

In-dash installation kit for 2003-up honda accord (lower dash pocket) vehicles

Advertisement

Quick Links

MOUNTING THE RADIO
CAUTION:
REAR SUPPORTING THE
RADIO ADDS TO THE
INSTALLATIONS
STRUCTURAL INTEGRITY.
5452
MOUNTING
KIT PANEL
RADIO'S
MOUNTING
SLEEVE
DIN
MOUNT
RADIO
5459
TRIM RING
SUPPORT
BRACKET
BEND TABS
OUTWARD
4
5324
REAR
5459
TRIM RING
Thank you for purchasing the Scosche HA1573 Kit. This kit was manufactured with the highest of
quality standards.
CAUTION:
Disconnect your vehicle's negative battery terminal before the installation to help prevent
electrical damage. We recommend the use of a volt/ohm meter over a test light to check
wiring. A test light or grounded wire probe can cause damage to the vehicle's computer and/
or diagnostic systems. Avoid all factory air bag wiring - air bags can accidentally deploy
causing serious injury or death.
NOTES:
See your vehicle's instructions for any special tools your installation might require.
Read all instructions accompanying your car stereo/cassette player for proper wiring and
mounting instructions.
This instruction booklet is based on carefully documented data and research of automobile dash
disassembly, wire harness/codes and information pertaining to installation of this kit (HA1573) in
2003-UP Honda Accord Vehicles. Scosche Industries, Inc. can not be held responsible for
discrepancies/inconsistencies that may occur due to the automobile manufacturing changes or
options, or damage that may occur in the automobile during the installation of components while
using this booklet.
IN-DASH INSTALLATION KIT FOR
2003-UP HONDA ACCORD
(LOWER DASH POCKET) VEHICLES
5125 POCKET
5452
MOUNTING KIT PANEL
INTRODUCTION / PRELIMINARY
LIABILITY DISCLAIMER
HA1573
5324
REAR SUPPORT
BRACKET

Advertisement

loading

Summary of Contents for Scosche HA1573

  • Page 1 5459 TRIM RING BEND TABS OUTWARD INTRODUCTION / PRELIMINARY Thank you for purchasing the Scosche HA1573 Kit. This kit was manufactured with the highest of 5459 TRIM RING quality standards. CAUTION: Disconnect your vehicle's negative battery terminal before the installation to help prevent electrical damage.
  • Page 2 Screw the two (2) supplied screws to screw emboss locations 3. Attach (2) white plastic retaining clips to the top brackets on the Scosche kit panel. See Illustration A. 4. Insert (2) screw brackets into openings in Scosche kit panel. See Illustration B.