Advertisement
Accessing 12V Power
4. Remove the accessory connection
panel from location and disconnect
the 12V power {A), and the Aux {B)
connection.
Testing Connection
Before proceeding to the preparation/installation please test the modules functionality by
connecting the provided vehicle specific I-harness (diagram below). Once the module is
connected, place the Qi-enabled device on the module and refer to the LED Status chart
below for specifics. For technical assistance with the installation please call or visit us on
the web at: 1-800-363-4490 x1
www .s co sch e.c om /co nta c t
Note: The module can also be tested by
connecting it to a USB to type-c connection
power source (not included).
FOREIGN OBJECT DETECTION: Please follow the MAGICPLATE'" mounting instruction on pages
2 or 3 for best charging results. Note that blocking the charging coil with anything metallic object
may cause the module to not work as designed.
BATTERY VOLTAGE REQUIREMENTS: The MQUSM (Qi Module) is designed to operate at
voltages between 13.2-14. 7. 11 your vehicle does not supply sufficient voltage with the ignition OFF,
you may need turn the ignition to the ON position in order to operate the MQUSM. For questions
about this product please contact our Scosche tech support team at: (800) 363-4490 ext. 1 or
www.scosche.com/contact.
LED CHARGING STATUS
The LED indicator on the side of the mount illuminates the charging status
of the device. When powered ON, the indicator blinks in the following
order: BLUE, GREEN, BWE.
Standby = Green
Charging = Blue
VEHICLE DISASSEMBLY
TESTING QI MODULE (MQUSM)
:���•
Female Comector to
12V harn ess conn ecto r
Male Connector lo
Back of 12V Socket
5
_ '3ack of Panel
To QI Module
(MQUSM)
Advertisement
