Table of Contents
Advertisement
2. Press down on the latch in the handle of the tray to release it, and slide the tray forward.
3. Set the adapter plate with attached card into the card tray so that it fits within the locators on
the card tray. The header on the cards should be on the left hand side. The tray holds a
maximum of two cards at a time. Both cards must be of the same type.
If loading only one card, place it towards the back of the tray leaving the area closest to you
empty. The correct area of the tray for printing a single card is marked with the numeral 1.
4. Slide the tray under the printer until it snaps into place and stops.
BradyJet J1000 User Manual
Setup
Loading Supplies
9
Advertisement
Table of Contents
