Installing The Service Station - Brady BradyJet J1000 User Manual

Installing the Service Station

The service station (J1000-PAD KIT) is an internal component
used to clean the printhead and to cap the ink nozzles when not
in use.
1 Cap
2 Wiper
3 Ink well
To install the service station:
1. On the printer touch screen, tap the Maintenance button.
2. Tap Service Station.
3. The printer moves internal components so that the service station dock is accessible. When it
is finished moving, open the cover on top of the printer.
4. Place the service station in its dock as shown below.
5. Close the cover on the printer and then tap OK on the touch screen.
BradyJet J1000 User Manual
When not printing, the printer positions the ink
cartridge so that the cap seals the printhead to
minimize ink evaporation.
When running a cleaning cycle, the printer
expels ink into the well and then wipes the ink
nozzles with the wiper.(See "Cleaning the
Printhead and Nozzles" on page 19.)
The ink well collects ink that is ejected from the
nozzles during a cleaning cycle.
Installing the Service Station
1
Setup
2
3
7