Side Glass Installation; Front Glass Installation - Dimplex IGNITE XL BOLD Installation And User Manual

Installation

Side Glass Installation

1. Ensure the matte side of the upper black trimming is
oriented toward the inside.
2. Insert the top of the glass panel into the upper slot.
3. Carefully tilt it toward the inside until it is in the vertical
position. Once in place, it will drop into the correct
position. (Figure 23)
4. Repeat on the other side for bay installations.

Front Glass Installation

1. Ensure there are no debris or finger prints on the
mirrored glass, inner sides of the side glass, or on the
inner side of the front glass before you begin.
2. Attach the provided suction cup to the outer side of
the front glass. Ensure the suction cup is securely
attached.
3. Using the suction cup to assist, lift the glass and place
it into the bottom slot at an angle.
4. Tilt the glass into a vertical position. (Figure 24)
5. Secure using the provided front glass brackets and
black screws provided. (Figure 25)
!
NOTE: There is 1 front glass bracket for the XLF5017-
XD, 2 front glass brackets for XLF6017-XD and
XLF7417-XD units and 3 front glass brackets for
XLF8817-XD and XLF10017-XD units.
CAUTION: Ensure the front glass does not fall forward
while the glass mounting brackets are being installed.
6. Remove the suction cup and clean any fingerprints or
debris off the glass with a nonabrasive glass cleaner.
!
NOTE: Do not dispose of the suction cup! Keep it in a
secure location, as it may be needed for maintenance
and service on this fireplace.
18
Figure 23
Figure 24
Figure 25
Front Glass Brackets
www.dimplex.com