Table of Contents
Advertisement
Operation
Standby
Flame Effect
Heat
Heat Disable
Temperature
Increase
Temperature
Decrease
Temperature
Display
(°C ↔ °F)
Flame Speed
Heat Mode
Moods
Custom Color
20
Press
to turn on the unit or to put it in standby mode.
When the unit is turned back on, it will retain the previously used settings.
Press
to turn the flame effect, media, and overhead lights on or off.
Press
to turn the heat on or off. The fireplace will beep once and the
remain on the display when activated.
The fireplace can be operated in heat only mode by turning off the flame and color
effects.
Press and hold
and
function. This action must be performed on the hidden touch controls.
When the heat is disabled and either the
display.
Press
to increase the temperature setting.
Press
to decrease the temperature setting.
The temperature can be set from 7° C to 30° C (45° F to 86° F).
When the temperature setting is adjusted, the set temperature will flash for 2 seconds,
then the ambient room temperature will be displayed briefly.
Press and hold
and
performed on the hidden touch controls.
Press
repeatedly to cycle through the 5 different flame speeds.
Press
repeatedly to cycle through the 4 different heater modes:
Normal: The element will automatically adjust itself to achieve and maintain the set
temperature.
Eco: The element will work at reduced power to save energy.
Heat Boost: The element will work at maximum power for 20 minutes, then revert to
normal heater mode.
Fan: The element will turn off and only the fan will run.
Press
repeatedly to cycle through the 8 different Moods, which are different
combinations of overhead and media bed lighting.
1 - White
2 - Blue
3 - Violet
4 - Red
5 - Green
6 - Prism — media and flame base cycle through colors
7 - Kaleidoscope— media and flame base cycle through colors at different rates
8 - Midnight mode — media and overhead lights are off
Press and hold
to turn the overhead lights on or off.
Freeze the media and overhead lights to a custom color.
When in Prism or Kaleidoscope modes (see Moods), press
displayed to freeze the cycle on that color.
Press
again to resume the color cycle.
at the same time for 3 seconds to disable or enable the heat
,
, or
at the same time for 3 seconds. This action must be
icon will
is pressed, --- will appear on the
while the desired color is
www.dimplex.com
Hide quick links:
Advertisement
Table of Contents
