Operation; Before First Time Operation; Checks Before Starting; Starting The Engine - Ferris 400S Series Operator's Manual

the parking brake. Pull the parking brake lever back, out away
from the operator, and allow it to travel forward to disengage
the parking brake.
Note: To start the unit the parking brake must be engaged.
Disengage
Engage

Operation

Before First Time Operation

• Be sure to read all information in the Safety and
Operation sections before attempting to operate this zero-
turn rider and mower deck.
• Become familiar with all of the controls and how to stop
the machine.
• Drive in an open area without mowing to become
accustomed to the unit.
WARNING
• Never operate on slopes greater than 10 degrees.
• Select slow ground speed before driving onto a slope.
Use extra caution when operating on slopes with a rear-
mounted grass catcher.
• Avoid turning down slopes; if possible turn up slopes.
Use caution when changing direction on slopes and do
NOT start or stop on a slope.
WARNING
• Never allow passengers to ride on the unit.
• Before leaving the operator's position for any reason,
engage the parking brake, disengage the PTO, turn the
ignition switch to OFF and remove the ignition key.
• To reduce fire hazard, keep the engine, rider and
mower free of grass, leaves and excess grease.
Do NOT stop or park rider over dry leaves, grass or
combustible materials.
• Fuel is highly flammable and must be handled with
care. Never fill the tank when the engine is still hot from
recent operation. Do NOT allow open flame, smoking or
matches in the area. Avoid over-filling and wipe up any
spills.
Do NOT load this zero-turn rider on a trailer or truck using
two separate ramps. Only use a single ramp that is at least
one foot wider than the width of the rear wheels of this rider.
Releases the parking
This rider has a zero turning radius and the rear wheels
brake.
could fall off the ramps, or the rider could tip over injuring
the operator or bystanders.
Locks the parking
brake.

Checks Before Starting

• Check that the crankcase is filled to the full mark on
• Make sure all nuts, bolts, screws and pins are in place
• Adjust the seat position, and make certain you can reach
• Fill the fuel tank with fresh fuel. Refer to engine manual
• Check the hydraulic oil level.

Starting the Engine

• If you do not understand how a specific control
• Do NOT attempt to operate the tractor without first
1. While sitting in the operator's seat, engage the parking
2. A warm engine may not require choking. Set the
3. Insert the key into the ignition switch and turn it to
4. After the engine starts, gradually open the choke (push
WARNING
the crankcase oil fill and dipstick. If necessary, add oil
through the engine oil fill. See the engine Operator's
manual for instructions, engine oil dipstick location and oil
recommendations.
and tight.
all the controls from operator's position.
for fuel recommendations.
WARNING
functions, or have not yet thoroughly read the Features
& Controls section, do so now.
becoming familiar with the location and function of all
controls.
brake and make sure the PTO switch is disengaged and
the ground speed control levers are locked in the neutral
position.
engine throttle control to FAST throttle position. Then fully
close the choke by pulling the knob OUT fully.
START.
knob down fully). Reduce to half throttle speed and allow
engine to warm. Warm up the engine by running it for
atleast a minute before engaging the PTO switch or
driving the rider.
15