Connecting And Disconnecting (Portable Models Only) - Haier HLV0845FSSS Owner's Manual

Built-in dishwasher, portable dishwasher
Table of Contents

Advertisement

Available languages

Available languages

USING THE DISHWASHER
CONNECTING AND DISCONNECTING
(PORTABLE MODELS ONLY)
Connect the Unicouple to the faucet (portable models only)
Run garbage disposer, if you have one, to clean out the dis-
poser and thus allow water to drain from the sink through the
disposer and down the drain.
Run hot water faucet to purge cold water from the hot water
line. The hot water must be between
for bestwash performance.
(66°C)
Roll the dishwasher to a position just in front of the sink.
Pull the unicouple and its hoses completely out from storage
compartment at rear of the dishwasher.
Attach the unicouple to the faucet adapter following the three
steps below:
- Depress the locking collar at the top of the unicouple.
- Place the unicouple completely over the faucet adapter.
- Release the locking collar. The unicouple should now be
locked onto the faucet adapter.
DISCONNECT AND STORE YOUR
DISHWASHER (PORTABLE MODELS
ONLY)
Remove power
Unplug the dishwasher.
Feed power cord back into its storage location.
Remove Unicouple from faucet
Turn off hot water.
Relieve water pressure from the unicouple assembly before
disconnecting it from the faucet by depressing the red pres-
sure relief button on the unicouple.
Depress red
button to release
water pressure
Depress the locking collar and remove the unicouple from the
faucet.
Depress collar to release
unicouple from faucet
10
120°F (49°C)
and
150°F
Turn on the hot water faucet and check for leaks. If a unicouple
leak was observed, take whatever actions are necessary to re-
pair the leak. This may be as simple as tightening the faucet
adapter. Or, it may require the services of a plumber if water is
leaking from the interface between the moveable faucet arm
and the fixed part of the faucet fastened to the sink.
NOTE: The unicouple's small hose carries water from the faucet
to the dishwasher. The large hose carries water from the dish-
washer to the sink. Orient the faucet with the unicouple attached
so water from the unicouple will run into the sink drain.
Plug the dishwasher power cord into the electrical outlet.
Drain excess water from the unicouple. If the sink is 34" or
higher from the floor, the excess water in unicouple hoses can-
not be drained directly into the sink. It will be necessary to
drain excess water from hoses into a bowl or suitable container
that is held outside and lower than the sink.
Feed the unicouple and hoses back into their storage pocket.
Store the dishwasher
Latch the dishwasher door closed.
Roll the dishwasher into its storage location.
Collar

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HLV0845FSSS and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Qdp225sspss

Table of Contents

Save PDF