Changing The Fuse In The Car Charger Adapter - Silvercrest SBTF 10 E5 Quick Start Manual

The mobile phone does not connect automat-
ically even though the auto power function is
switched on.
♦ Depending on the mobile phone used, it is possible
that the automatic connection cannot be made . If this
happens, press the
connection .
♦ With some mobile phones, the connection must also be
confirmed on the mobile phone itself . Please also refer
to the operating instructions for the respective mobile
phone .

Changing the fuse in the car charger adapter

There is a fuse in the car charger adapter
vehicle's on-board power supply . If the device stops working,
check the fuse and replace it if necessary .
♦ Open the car charger adapter
insert (C) carefully anticlockwise with a pair of pliers
and carefully removing it .
♦ Remove the plug tip (B) from the fuse (A) and pull out
the fuse .
♦ Now, insert a new fuse (type F2AL 250 V) into the car
charger adapter
protruding end of the fuse and screw the previously
removed screw insert (C) back in .
DANGER
► Replace the fuse only with another of the same type .
Fuses with a different rating could cause a fire .
NOTICE
► If the device still does not work or the fuse blows
again immediately, the device is defective . In this
case, please contact the Service Hotline (see section
"Service") .
SBTF 10 E5
button
, fit the plug tip (B) onto the slightly
briefly to restore the
to protect the
by turning the screw
GB │ IE │ NI │ 19 ■