Start Up - Hussmann Entyce TY3 Series Installation & Operation Manual

Start up

Startup Instructions
1. Turn Power to ON
2. Preheat merchandiser for 10 minutes before loading.
3. Load fully cooked / heated foods only (internal product
temperatures > 160°F). Case is not designed to heat food.
4. Use only approved hot food containers in direct contact
with shelves; Do NOT stack containers.
5. Check Internal Product Temperature periodically, using a
pocket food thermometer.
6. Adjust *SHELF Setpoint as needed to maintain ideal Inter-
nal Product Temperatures:
• (1) Press SET key, (2) Press UP ARROW / DOWN AR-
ROW keys to change *SHELFSetpoint, (3) Press SET
key again.
• When increasing *SHELF-temperatures, heat food in a
separate cooking/warming oven, then reload.
NOTES:
- *Controller temperature indicates SHELF-
temperature only (not Internal Product
Temperature).
- Shelves are pre-set to 185°F, suitable for
many foods in approved containers. Do not
overheat as containers may melt.
- Refer to Instruction Manual for detailed
operating instructions.
- Refer to NSF- and local- regulations for
internal product temperature requirements.
- SERVICE: For heated component failures,
contact HATCO Parts and Service at 800-558-
0607.
Operation
• Food must be preheated BEFORE loading; this case
MUST NOT be used to cook or heat product.
• Check Internal Product Temperatures (IPTs) periodi-
cally with a portable food thermometer
• Do not stack containers.
• Be careful not to overheat as containers may melt.
• When restocking, rotate food products: oldest foods
should be placed in front and served first.
• Wipe spills immediately to maintain product fresh-
ness, minimize odors, reduce end-of-day cleanup (See
Maintenance Section).
Adjustment
• Use a pocket food thermometer regularly to check
internal product temperatures.
• Before adjusting shelf temperatures, ensure only pre-
heated foods are being loaded into the case.
• Shelves are pre-set to 185°F, suitable for many food
and container types.
• Adjust SHELF-Setpoint as needed to maintain ideal
Internal Product Temperatures:
(1) Press SET key,
(2) Press UP ARROW / DOWN ARROW keys
to change *SHELF-Setpoint,
(3) Press SET key again.
(4) When increasing SHELF-temperatures,
heat food in a separate cooking/warming
oven, then reload.
• Temperature controls should be adjusted to the low-
est possible setting that will maintain proper internal
product temperature.
• See troubleshooting guide if, after adjustment, pre-
heated product does not maintain regulatory tem-
perature.
Holding Temperature Guide
• Food must be preheated BEFORE loading the case; the
case must not be used to heat product.
• Always consult local health and sanitation regulations
for internal product temperature and holding require-
ments.
• Holding Temperatures listed below are internal prod-
uct temperatures, and are guidelines only.
HOLDING TEMPERATURE GUIDELINES* Internal
Product Temperatures (IPT)
MEAT
CHICKEN / POULTRY
8
*IPT
160° - 175°F