Table of Contents
Advertisement
Further indications are given in the single chapters and in the user instructions.
Open the door
How to fill the
detergent dispenser
Check the rinse aid level
Check the
regeneration salt level
Load the racks
Close the door,
select a programme
Select
additional options
Turn on the water tap
Press the Start button
to start the programme
(during the cycle the
Start indicator blinks)
Switch off the appliance
Turn off the water
tap, unload the racks
How to use the appliance
Large compartment A
Small compartment B
Mechanical indicator lamp C.
Electric indicator on control panel (if provided).
On models with water softener system
only.
Mechanical indicator lamp D.
Electric indicator on control panel
(if provided).
Refer to the dishwasher loading instructions.
Press and turn the selector knob
switch on the appliance.
If necessary (and if provided).
The corresponding indicator lamp lights up.
"Cancel"
Press and hold the "Start" button
until the indicator lamp stops
blinking and stays on.
Press and hold the "Start" button
for 10 seconds. "P0" will appear on
the display and the programme will
stop.
To switch off the dishwasher turn the selector knob
All the indicator lamps and the display switch off.
Warning: When the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
A B
D
to select the desired programme and
"Change programme in
progress"
Press and hold the "Start" button
until the indicator lamp stops blinking
and stays on.
Select and start the programme as
described previously.
- Only open the dishwasher if
necessary (Warning: beware of
hot steam).
- If the appliance is switched off
during a wash cycle, when
switched on again it will resume
the cycle from where it was
interrupted.
to off.
C
Advertisement
Table of Contents
