Bauknecht GSX 5503 Manual
Bauknecht GSX 5503 Manual

Bauknecht GSX 5503 Manual

Advertisement

Quick Links

Before using the dishwasher, read the installation and maintenance instructions carefully!
GB
GSX 5503
Programme selection button
Press the button (repeatedly) until the indicator
lamp of the desired programme lights up (see
table 1.1).
At the end of the wash cycle, the last
programme selected is memorized.
Start/Resume button
The indicator lamp lights up during operation,
flashes when the programme is interrupted
before completion and switches off at the end
of the programme.
Cancel/Off button
Press the button to switch the dishwasher off or
to interrupt the selected programme.
If the Cancel/Off indicator lamp flashes
repeatedly, this indicates a fault: see chapter 5
"What to do if...".
Overview of programmes
P
Programmes
1
Pre-Rinse
2
Glasses
3
Quickwash
4
Bio Normal
5
Intensive
1)
Programme data obtained in conformity with European standard EN 50242. The data may vary, for example,
according to different loads, extra functions, different settings, water supply temperatures, water hardness and
power supply voltage.
2)
Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories: for detailed
information on the EN/Standard loading comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
1. OVERVIEW
Table 1.1.
Description of programme
cold
Crockery to be washed later.
Light soiling, for example glasses
40°C
and cups.
Lightly soiled crockery, with no
40°C
dried-on food.
Normally soiled crockery.
2)
50°C
Energy-saving programme.
Recommended programme for
70°C
heavily soiled crockery, especially
suitable for pots and pans.
Detergent
Consumption
dispenser
large small Litres kWh
5.0
0.02
X
13.0
0.90
X
13.0
0.70
X
X
15.0
1.05
X
X
15.0
1.50
5019 496 01150
1)
Minutes
1)
10 ±
1)
97 ±
1)
30 ±
1)
165 ±
1)
140 ±
1

Advertisement

Table of Contents
loading

Summary of Contents for Bauknecht GSX 5503

  • Page 1 Before using the dishwasher, read the installation and maintenance instructions carefully! GSX 5503 1. OVERVIEW Programme selection button Press the button (repeatedly) until the indicator lamp of the desired programme lights up (see table 1.1). At the end of the wash cycle, the last programme selected is memorized.
  • Page 2 2. QUICK REFERENCE GUIDE Detailed instructions are given on the following pages; also see section “5. What to do if...”. The dishwasher switches on automatically when any button is pressed, except for the 1. Switch the button. If no button is pressed within 30 seconds, the appliance switches to Energy appliance on Saving mode.
  • Page 3: How To Use The Appliance

    3. HOW TO USE THE APPLIANCE HOW TO FILL THE DETERGENT DISPENSER Only fill the detergent dispenser prior to starting a wash programme. Only use detergents specially recommended for dishwashers, observing the manufacturer’s recommended dosage. Observe the manufacturer’s safety warnings! Press the left button (button 1) on the dispenser to open the detergent dispenser compartments.
  • Page 4 3. HOW TO USE THE APPLIANCE HOW TO CHECK/FILL/ADJUST SALT Only use regeneration salt specifically intended for dishwashers. a. How to check the salt level Depending on the model, check the visual indicator . The window on the salt reservoir cap is clear when salt needs to be added and coloured when the salt present is sufficient.
  • Page 5: How To Load The Racks

    3. HOW TO USE THE APPLIANCE HOW TO LOAD THE RACKS UPPER RACK - depending on model: Adjustable glass holder A Depending on the position, for small glasses or stemware. Crockery holder B Horizontal for: cups/long utensils, in raised position for plates and stemware.
  • Page 6: Precautions And General Recommendations

    4. PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packaging The packaging materials are 100% recyclable and marked with the recycling symbol 2. Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher has not been damaged during shipping and that the door closes correctly.
  • Page 7 5. WHAT TO DO IF... If a fault occurs, before contacting the After-Sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance...
  • Page 8 5. WHAT TO DO IF... Crockery and cutlery ... Possible causes/solutions ...are not perfectly clean/have food In the event of frequent use of low temperature programmes residues (50°C or lower) (if available), every now and again select a higher temperature programme The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see the instructions in “Maintenance and installation”).

Table of Contents