Before using the dishwasher, read the user instructions!
GSI 6497
Programme selector knob
On / Off button
Start button
Switches "on" when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Add rinse aid
Programme chart
Programmes
Pre-Rinse
Rapid 30 min 40°C
1)
Normal
Intensive
1)
Reference programme for energy label in
compliance with EN 50242 regulations;
2)
Refer to "User instructions";
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
Quick Reference Guide
Loading instructions
cold
Crockery to be washed later.
Lightly soiled crockery with no
dried-on food.
50°C
Normally soiled crockery.
Heavily soiled crockery, especially
70°C
pots and pans.
Wash cycle
Pre-Rinse
Washing
Options
"Delayed start" buttons
The wash cycle can be programmed to start
after 1-9 hours. Then press the Start button.
The wash programme will start at the set
time.
"Half Load" button
This function can be used with any
programme. The indicator lamp switches on.
The wash cycle is activated for the upper or
lower rack only.
When washing without the top rack, press
the "Half Load" button (LED alight).
2)
Detergent
A
B
-
-
X
-
X
X
X
X
3)
Program data obtained in conformity with
European standard EN 50242. Values may vary in
relation to usage, e.g.: different loads, water
temperatures - above or below 15°C - as well as
water hardness and power supply voltage, etc.
5019 496 90342
(We reserve the right to make technical modifications)
GB
Programme
Drying
end
3)
Consumption
Litres
kWh
Minutes
4.0
0.03
14
10.0
0.65
30
13.0
1.05
145
14.0
1.70
150