Advertisement
Quick Links
Instructions for use
GSI 7990
Bauknecht AG, Industriestrasse 36, 5600 Lenzburg, www.bauknecht.ch
Verkauf
Telefon 0848 801 002
Kundendienst
Telefon 0848 801 001
Ersatzteile
Telefon 0848 801 005
Fax 0848 801 017
Fax 0848 801 003
Fax 0848 801 004
verkauf@bauknecht.ch
service@bauknecht.ch
ersatzteilverkauf@bauknecht.ch
Advertisement
Related Manuals for Bauknecht GSI 7990
Summary of Contents for Bauknecht GSI 7990
- Page 1 Instructions for use GSI 7990 Bauknecht AG, Industriestrasse 36, 5600 Lenzburg, www.bauknecht.ch Verkauf Telefon 0848 801 002 Fax 0848 801 017 verkauf@bauknecht.ch Kundendienst Telefon 0848 801 001 Fax 0848 801 003 service@bauknecht.ch Ersatzteile Telefon 0848 801 005 Fax 0848 801 004...
- Page 2 1. Water connection Connection to the mains water supply must be carried out by a qualified technician in compliance with the manufacturer's instructions and applicable local safety regulations. All local water board regulations must be complied with. Water supply pressure: 0.03 - 1.0 MPa. The inlet hose must be securely clamped to the water tap to prevent leaks.
-
Page 3: Electrical Connection
ELECTRICAL CONNECTION 1) For Great Britain only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1. - Page 4 700 x 75 mm 300 x 75 mm 2x / 4x 2x /4x 1/2” - 3/4” 25 - 29 mm 3,0 x 12 mm 3,5 x 16 mm 4,0 x 40 mm...
- Page 7 820 - 900 mm...
- Page 8 850 - 900 mm...
- Page 11 Y(mm)-X(mm)= min.87mm...
- Page 12 1,2,3,…? 4619 727 65951 16-22,6mm 592 / 594mm...
- Page 13 max. 2mm...
- Page 14 10a./10b. 10a. 10b.
- Page 19 Before using the dishwasher, read the installation and maintenance instructions carefully! GSI 7990 1. OVERVIEW Fault indication and wash time display In normal operation it indicates the remaining time (h:mm), whereas with “Delayed start” selected it indicates the time Programme selector remaining until programme start (hh).
- Page 20 2. QUICK REFERENCE GUIDE Detailed instructions are given on the following pages; also see section “5. What to do, in case of...” 1. Switch on the Press the ON/OFF button. appliance Press the button “Select programme” or the programme selector to display the 2.
-
Page 21: How To Use The Appliance
3. HOW TO USE THE APPLIANCE PROGRAMME SELECTION Press the button “Select programme” or the programme selector to display the selected programme. The appliance must be switched on. If required, select possible options. The corresponding indicator lights up. The correct programme and the selectable functions are given in table 1.1 on page 1. Programme times stated in the table were obtained under normal conditions and may vary depending on conditions. - Page 22 3. HOW TO USE THE APPLIANCE c. How to adjust the rinse aid dosage regulator The rinse aid dosage can be adjusted to the detergent used. The lower the setting, the less rinse aid is dispensed (factory setting: position 4). Press the lever 2 to open the cover.
- Page 23 3. HOW TO USE THE APPLIANCE HOW TO LOAD THE RACKS CUTLERY RACK: Position 1 Position 2 May be used in two different positions. In position 2 the upper rack must be lowered (see “Upper rack height adjustment” C below). For optimum washing results, position cutlery as shown (handles of spoons facing inwards).
-
Page 24: Precautions And General Recommendations
4. PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packing The packaging materials are 100% recyclable and marked with the recycling symbol. 2. Removing the packaging and inspecting the contents After unpacking, make sure that the dishwasher is undamaged and that the door closes correctly. If in doubt, contact a qualified technician or your local retailer. - Page 25 5. WHAT TO DO IF... If a fault occurs, before contacting the After-sales Service, make the following checks to try and remedy the problem. Most faults can be remedied by taking the following courses of action, quickly restoring normal appliance operation. The appliance...
- Page 26 5. WHAT TO DO IF... Crockery and cutlery ... Possible causes/solutions ...are not perfectly clean/have food In the event of frequent use of low temperature programmes residues (50°C or lower) (if available), every now and again select a higher temperature programme The spray arms must not be clogged, the filters must not be dirty and must be fitted correctly (see the instructions in “Maintenance and installation”).