Bauknecht GSIP 6527 User Instructions

GSIP 6527
Programme selection button
On / Off button
Start button
Switches "on" when the dishwasher is operating.
Flashes when a fault occurs. Switches off at the
end of the programme.
Programme chart
Programmes
Pre-Rinse
Rapid 30 min
1) 5) 6)
Bio
5)
Standard
5)
Intensive
1) Reference programme for energy label EN 50242;
2) Refer to "User instructions";
3) Programme data obtained in conformity with European
standard EN 50242. Values may vary in relation to usage,
e.g.: different loads, options, water temperatures - above
or below 15°C - as well as water hardness and power
supply voltage, etc.
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
Before using the dishwasher, read the user instructions!
Quick Reference Guide
Loading instructions
cold
Crockery to be washed later.
Lightly soiled crockery with no dried-on
40°C
food.
50°C
Normally soiled crockery.
60°C
Normally or heavily soiled crockery.
Recommended programme for heavily
70°C
soiled crockery, especially suitable for
pans and saucepans.
3)
Options
Time and failure display
Indicates in hours the time remaining until the start of
the wash cycle. Switches off at programme start and
indicates the remaining time in hours and minutes.
"F...." Information for the After-Sales Service
"Delayed start" button
The wash cycle can be programmed to start after 1 - 24
hours. With each successive touch of the button, the
delayed start indicator increases by 1 hour, and after 24
returns to 00. Then press the Start button. The
dishwasher will start at the set time.
"Half load - Multizone" button
Load the upper or lower rack only.
This function can be used with any programme.
Press once = upper rack (the indication lamp/symbol comes on)
Press twice = lower rack (the indication lamp/symbol comes on)
Press 3 times = Off (half load function deactivated).
When washing without the top rack, press the "Half
Load" button twice, or "Lower rack wash" (the
corresponding LED/symbol comes on).
Antibacterial rinse
This function adds an antibacterial rinse at the end of the
wash cycle, thereby guaranteeing a perfectly clean and
sanitized load. The lamp will light up when the function
is activated. If the temperature is not maintained during
the antibacterial cycle (e.g. if the door is opened and
remains open for a long time), the lamp will start blinking
to indicate that sanitation is not guaranteed.
2)
Detergent
A B
- -
X -
X X
X X
X X
4) The bacteria removal efficiency has been tested by the
Institut Pasteur de Lille (France), based on the NF EN
13697 standard of November 2001.
5) These programmes can be used with the Antibacterial
rinse option.
6) Energy saving programme with prolonged drying cycle.
(We reserve the right to make technical modifications)
GB
4) 5)
3)
Consumption
Litres kWh Minutes
4.0 0.03 14
10.0 0.65 30
13.0 1.05 195
13.0 1.25 120
14.0 1.55 155
5019 496 90462