Safety Approval Markings And Safety Tips; Ce Conformity; Fulfilling Of Namur Recommendations - Vega VEGAFLEX 65 Operating Instructions Manual

2 For your safety
6
During the entire duration of use, the user is obliged to
determine the compliance of the required occupational safety
measures with the current valid rules and regulations and also
take note of new regulations.

2.5 Safety approval markings and safety tips

The safety approval markings and safety tips on the device
must be observed.

2.6 CE conformity

The protection goals of the EMC Directive 2004/108/EC (EMC)
and the Low Voltage Directive 2006/95/EC (LVD) are fulfilled.
Conformity has been judged according to the following
standards:
EMC: EN 61326-1: 2006
(electrical instruments for control technology and laboratory
use - EMC requirements)
Emission: Class B
l
Susceptibility: Industrial areas
l
LVD: EN 61010-1: 2001
(safety regulations for electrical measurement, control and
laboratory instruments - part 1: General requirements)
2.7 Fulfilling of NAMUR recommendations
With respect to interference resistance and emitted interfer-
ence, the NAMUR recommendation NE 21 is fulfilled.
With respect to compatibility, the NAMUR recommendation
NE 53 is fulfilled. This applies also to the corresponding
indicating and adjustment components. VEGA instruments are
generally upward and downward compatible.
Sensor software for DTM VEGAFLEX 65 HART, PA or FF
l
DTM VEGAFLEX 65 for adjustment software PACTware
l
Indicating and adjustment module for sensor software
l
The parameter adjustment of the basic sensor functions is
independent of the software version. The range of available
functions depends on the respective software version of the
individual components.
The software version of VEGAFLEX 65 can be determined as
follows:
VEGAFLEX 65 • Foundation Fieldbus