Operation And Use; Machine Statuses; Manual Start-Up; Programmed Automatic Start-Up - Saeco IDEA RST Technical Manual

English
9

OPERATION AND USE

Before using the machine, read this manual
carefully and make sure users are familiar
with the machine.
After the machine has not been used for a
certain time, it is recommended to read
section "First Use - Use after a Long
Period of Inactivity" again, before using the
module again.
The use by children older than 8 years or
by persons with reduced physical, mental
or sensory abilities or with lack of
experience and skills is allowed, provided
that they are supervised or instructed on
how to use the appliance correctly and
that they understand the hazards involved.
Children must not play with the appliance.
Children must not carry out any cleaning
and maintenance operations without being
monitored.
9.1

Machine Statuses

With regard to the power supply, the machine can have the following
statuses:
Off and electrically insulated
• Power button and all-pole switch is set to "0" (or plug disconnected).
• Only the memory for the programmed data storing is active.
On
• Power button and all-pole switch is set to "I" (or plug connected).
• All the functions are active and the display is on.
In standby mode (machine switched off but not electrically insulated)
• Power button is set to "I".
• The following functions are active: "AUTOMATIC START-UP",
"ANTIFREEZING", if selected, and "Clock", as well as the display and
the memory for the programmed data storing.
• The display backlighting is off.
9.2

Manual Start-up

This start-up is necessary when the machine is in the "off and
electrically insulated" status.
Proceed as explained in section "First Appliance Start-up".
42
9.3

Programmed Automatic Start-up

This start-up is possible when the machine is in "STANDBY" mode
and the function "AUTOMATIC START-UP" is active.
The machine will switch-on at the programmed time.
9.4

Stand-by Temporary Start-up

Manual switching-on when the machine in "STANDBY" mode.
This is possible by pressing the button shown in the figure for 3 seconds.
The machine will automatically go back to the "STANDBY" mode
after 30 minutes from the last operation, if still within the
programmed standby time.
9.5

Beverage Selection

The conditions necessary to select a beverage are the following:
• the appliance has reached the set temperature after the start-up.
Otherwise, the display will show the message "HEATING";
• There is no error condition that prevents brewing beverages.
Otherwise, the display will show the error message;
• the selected beverage is enabled. Otherwise, the keypad shows the
beverage off icon;
When dispensing a beverage:
• The display shows the dispensing beverage icon.