Honda E Manual page 564

Charge the High Voltage battery using a AC or CCS2 DC charger
There are two ways to charge the High Voltage battery; by using a professionally
installed AC 230 volt or CCS2 DC charger.
Charging with
CCS2 DC
AC 230V (32amp)
*1:
Charging time varies depending on conditions, such as the remaining battery level and the ambient
temperature.
The suggested full charging time in this table indicates the hours it may likely take
for the High Voltage battery to be fully charged from the moment the low charge
indicator comes on with the ambient temperature at 77°F (25°C).
uuCharginguCharge the High Voltage battery using a AC or CCS2 DC charger
Suggested charging time
30 minutes (80% charge) *1
5-10.5 hours (full charge) *1
Continued
1Charging
When the battery warming system is activated, the
battery may take longer to charge.
When the 12-volt battery is disconnected, vehicle
charging is not possible. After reconnecting the
12-volt battery, turn the power system on, then turn
it off.
Confirm that charging is possible.
2 Turning on the Power P. 381
WARNING
3
Charging the High Voltage battery under
the following conditions is a potential
source of electric shock and fire, which can
result in serious injury or death:
• Charging the battery during an electric
storm.
• Using the charging cable near water or
handling with wet hands.
• Using a charger, whose case is broken or
cracked or whose cable is frayed or
damaged.
Never charge the vehicle in any of the
above situations.
563