Top Filling The Soap Dispenser - Bradley Verge Crestt Series Installation And Maintenance Manual

Installation
7

Top Filling the Soap Dispenser

When the soap level is at approximately 25%
capacity, the LED indicator on the shank will
flash red, indicating low soap levels.
Soap tank capacity is 70.5 oz (2080 mL).
Insert the supplied 3 mm hex Allen wrench into the
A
opening on the lower right-hand side of the spout.
Turn the Allen wrench counter-clockwise to loosen
the cap screw that secures the spout assembly to
the shank.
Use a straight, upward motion to carefully lift the
spout assembly from the shank, and set the spout
B
assembly on its side within 3"–4" from the shank.
The spout automatically powers off when it is
removed from the shank, preventing soap from
dispensing.
If the spout assembly does not easily lift
from the shank, use the Allen wrench
to loosen the cap screw until the spout
assembly detaches.
C
Slowly pour the soap into the soap fill port located
at the center of the shank.
To prevent overfilling, the LED indicator
on the shank will turn solid red and an
audible indicator will sound for 2.5 seconds,
indicating that soap levels are at 80%
capacity.
D
Align the 3 tapered posts with the mating holes in
the spout and carefully place the spout assembly
back onto the shank.
Assistance with the tethered coil sensor
wire may be needed to properly place the
spout assembly onto the shank.
E
Use the Allen wrench to tighten the cap screw,
securing the spout assembly to the shank.
Bradley • P20-224 Rev. A: ECO 19-15-015A
Verge Deck-Mounted Soap Dispensers
®
Cap screw is located
inside of the spout.
3 mm Hex Allen
Tethered Coil
Sensor Wire
Soap Fill
Port
LED
Indicator
2/10/2020
Wrench
Tapered Post
Cap Screw
Soap Supply
Port
9