Control Box Mounting - Bradley Verge Crestt Series Installation And Maintenance Manual

Verge Deck-Mounted Soap Dispensers
®
2

Control Box Mounting

A
Locate the mounting position for the
control box assembly.
The bottom of the tank must be
mounted between 17¹⁄₂" & 22¹⁄₂" from
the top of the deck, and 2¹⁄₂" right or
left of center of shank.
Use a level to ensure the control box
B
assembly is level, and then mark two
mounting hole locations on the wall using
a pencil.
C
Drill the two 1/4" diameter mounting
holes into the wall or surface, using a drill
and appropriate drill bit.
D
Use the supplied mounting screws (or
suitable mounting hardware) to attach the
control box assembly in place.
Appropriate fastener anchors and
mounting hardware must be used
when mounting the control box
assembly in the desired surface.
6
2¹⁄₂" Offset (max) Right or
Left From Center
Control Box
Assembly
12¹⁵⁄₁₆"
(328)
Mounting
Screws
2/10/2020
3¹⁄₈" (79)
Fastener
Anchors
Bradley • P20-224 Rev. A: ECO 19-15-015A
Installation
Shank
Mounting Holes
17¹⁄₂" (444)
22¹⁄₂" (571)
12¹⁄₄"
(311)
1/4" Dia.
Mounting Holes