Commissioning; Capacitor Connection; Description Of The Capacitor Kit; Diagnosis - Bosch rexroth NYCe 4000 Instructions Manual

14/19

Maintenance

11 Commissioning

11.1 Capacitor connection

The capacitor of a Capacitor Kit is connected to a header on the base plate of
the system housing which is marked with the text "CAPx" (where x can be 0, 1,
2, 3, 4, representing a specific drive slot in the module holder of the system
housing).
Via the "DPx" headers on the base plate the drive power supply voltages are
connected to each drive slot. This drive power voltage is also connected to the
"CAPx" header.
If the drive power supply has been connected with wrong polarity, the Capacitor
Kit must be replaced. If electrolyte has leaked from the capacitor, the Capacitor
Kit must be replaced and all components exposed to the electrolyte must be
replaced.

12 Description of the Capacitor Kit

The Capacitor Kit consists of a capacitor, a capacitor clamp, two mounting
screws and a metal cover which are mounted on a mounting bracket on the left
or right side of the module holder of the system housing.
CAUTION
The metal cover is part of the safety measures and must be installed.

13 Diagnosis

No diagnosis is available for the Capacitor Kit.
14 Maintenance
The Capacitor Kit has no special maintenance requirements.
Bosch Rexroth AG R911172629_Edition 06
NYCe 4000 Multi-axis motion control
Injury may occur if specifications of the
capacitor are exceeded.
system