Mechanical Dimensions - Bosch rexroth NYCe 4000 Instructions Manual

NYCe 4000 Multi-axis motion control
system
NOTICE
Make sure that the Capacitor Kit NYA04.1-CAP-100V-NY4921 is upgraded to
NYA04.1-CAP-200V-NY4921/10 before you connect a (higher) DP drive voltage, if
the slot was previously configured for an NY4120 or NY4125 drive module and
now used for an NY4140 drive module.
NOTICE
Observe the correct polarity of the connection of the DP drive power header.
NOTICE
Make sure power supplies are switched off before installation or removal of
●
the Capacitor Kit.
Do not apply power until the Capacitor Kit is installed.
●
NOTICE
Make sure that the plug of the Capacitor Kit is inserted in a header marked
"CAPx" (where x can be 0, 1, 2, 3, or 4).
Power supplies must be switched on/off with the disconnecting device installed
in the cabinet.

10.2 Mechanical dimensions

The dimensions of the Capacitor Kit are the following.
Type code
NYA04.1-CAP-100V-NY4921
NYA04.1-CAP-200V-NY4921/10
Tab. 10-1: Capacitor Kit mechanical dimensions
You can see the dimensions of the Capacitor Kit in the following views.
Damage to the capacitor may occur if the
working voltage is too high.
The system housing has no provisions against
wrong polarity connection of the capacitor.
Damage to components may occur if power is
applied during installation or removal.
Damage to the capacitor may occur if the plug
is connected in the wrong header. Do not use
the FAN header.
Width (mm) Height (mm)
43.6 58.0
R911172629_Edition 06 Bosch Rexroth AG
Installation and Removal
Depth (mm)
46.0
9/19