Sources Of Danger; Mains Operation - Aliaxis FRIATEC FRIAMAT basic 7th generation Operating Instruction

2.3

Sources of danger

WARNING!
Electric shock from live parts! Danger of death!
• Never leave the FRIAMAT fusion unit unattended.
• Immediately replace damaged housings, connecting lines, and extension cables.
Stop using the FRIAMAT fusion unit.
• Before all care and maintenance work, pull out the plug connecting the
equipment.
• Maintenance and repair work must be performed by authorised Aliaxis
Deutschland service stations only.
• Supply FRIAMAT fusion units only with the operating voltage specified on
the ratings plate.
• Fit a residual current protective device (RCD) when this is prescribed.
• Do not remove or otherwise put safety installations out of operation.
• Immediately eliminate identified defects.
WARNING!
Danger of fire and explosion from highly flammable materials and potentially
explosive atmospheres!
• Keep away from flammable liquids and gases.
• Do not use in potentially explosive atmospheres (e.g. in areas where flammable
gases, solvent vapours, or ignitable dusts can accumulate).
• Never leave the FRIAMAT fusion unit unattended.
2.4

Mains operation

Out of doors (building sites), power outlets must be fitted with residual current
protective devices (RCDs). The regulations governing RCDs must be observed
here.
NOTICE
Before commencing fusion, check the input voltage. The FRIAMAT fusion unit is
designed for an input voltage range of 190-250 V!
6