Gx270H Crankshaft Oil Seal Replacement; Side); Gx390H1 Balancer Weight Bearing/Governor Arm Shaft Oil Seal/Crankshaft Oil Seal Replacement (Cylinder Barrel Side) - Honda GX270H Manual

62Z7B000.book 27 ページ ２０１２年９月２７日 木曜日 午前１０時２１分
dummyhead dummyhead
GX270H CRANKSHAFT OIL SEAL
REPLACEMENT (CYLINDER BARREL

SIDE)

CRANKSHAFT OIL SEAL (30 x 46 x 8
mm)
Remove the oil seal from the cylinder barrel.
Drive a new oil seal [1] in the position as shown using
the special tools.
TOOLS:
Attachment, 45 x 50 mm [2]
Driver handle [3]
Apply grease to the lip of a oil seal.
GX390H1 BALANCER WEIGHT
BEARING/GOVERNOR ARM SHAFT OIL
SEAL/CRANKSHAFT OIL SEAL
REPLACEMENT (CYLINDER BARREL
SIDE)
BALANCER WEIGHT BEARING (6202)
Pull out the radial ball bearing [1] using the special
tools.
TOOLS:
Bearing remover shaft set,
15 mm [2]
Sliding hammer weight [3]
Drive a new bearing [4] until it is fully seated on the end
using the special tools.
TOOLS:
Attachment, 32 x 35 mm [5]
Pilot, 15 mm [6]
Driver handle [7]
[3]
[2]
07946-6920100
07749-0010000
2.0 mm (0.08 in)
(Lips)
[3]
07936-KC10500
07741-0010201
[2]
07746-0010100
07746-0040300
[1]
07749-0010000
[7]
[5]
CRANKCASE
[1]
[4]
[6]
14-27