Honda GX270H Manual page 116

62Z7B000.book 11 ページ ２０１２年９月２７日 木曜日 午前１０時２１分
dummyhead dummyhead
GX390H1:
NUT (6 mm) (2)
2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
LOCK WASHER (2)
STARTER
SOLENOID WIRE
STARTER
SOLENOID
BRUSH HOLDER INSTALLATION
(GX270H ONLY)
Note the installation direction.
Install the insulator [1], brush holder [2], negative brush
terminals [3], and two 4 x 14 mm screws [4] to the
center bracket as shown.
Install the brush springs [5] and brushes, and push the
brushes in the holders with a suitable wire [6] so that
they do not interfere with the commutator.
SCREW (5 x 32 mm) (4)
5.0 N·m (0.5 kgf·m, 3.7 lbf·ft)
WASHER (4)
SCREW (5 x 14 mm) (2)
5.0 N·m (0.5 kgf·m, 3.7 lbf·ft)
CENTER BRACKET
ASSY.
WASHER
REDUCTION
GEAR
OVERRUNNING
CLUTCH
STARTING SYSTEM
HOUSING
ASSEMBLY:
Make sure there is no
obstruction on the magnets.
DRIVE PINION
GEAR
RETAINER
RING
NUT (6 mm)
3.7 N·m (0.4 kgf·m, 2.7 lbf·ft)
DRIVE SIDE
PINION GEAR HOUSING
[4]
[3]
[1]
[6]
[5]
GASKET
ARMATURE
STARTER
SOLENOID WIRE
[2]
10-11