Table of Contents
Advertisement
Available languages
Available languages
1.
Turn on the ignition.
2.
The LED will begin to blink rapidly.
3.
Turn on the aftermarket radio.
4.
The following buttons must be pressed in order:
•
Each button pressed will be acknowledged by the LED steadily.
If any of the above buttons are not present, substitute with Volume Up. For example,
if a vehicle does not Band and Fan Up, you would press Volume Up, Seek Up, Volume
Up, PTT/MUTE, Volume Up.
•
After you have pressed five buttons, the LED will turn off.
If you press the buttons incorrectly, turn off the ignition and repeat the above
steps. If you do it wrong, it can be done again by pressing the volume up button for
15 seconds until the LED goes into fast blink mode again.
testing the GMoS-100
•
Turn the ignition on, and then turn the aftermarket radio on.
•
Push the OnStar button, the radio should turn off (radio will mute if mute wire is
connected) and you should hear OnStar.
•
Push the OnStar cancel button and the radio should come back on.
Chime volume adjustment
1.
With car on, shut off car and leave keys in ignition. Open the car door and leave it open.
Chimes will be heard.
2.
Wait 10 seconds, then with a small screwdriver adjust the potentiometer fully
counterclockwise (all the-way left), then clockwise to raise chime level and
counterclockwise to lower the chime level.
3.
When the volume is at the desired level, remove the keys from the ignition. This will
lock the chime volume at its current level.
Continued on next page
GMLAN11-100
Programming SWC
1
Volume Up
2
Seek Up
3
Band
4
PTT/Mute
5
Fan Up
6
Advertisement
Chapters
Table of Contents
