Remapping The Swc Buttons - Metra Electronics Axxess GMLAN11-100 Installation Instructions Manual

3.
Press and hold the "Volume Down" button for 5 seconds to finish programming.
The LED will then go off.
4.
After a few seconds, the LED will then blink the number of times corresponding
to the radio type. Verify that the number of blinks are the same number of times the
"Volume Up" button had been pressed.

Remapping the SWC buttons

Let's say you have already programmed the GMOS-100 to your vehicle and radio. The
scenario is: Now you would like to change the button assignment for the steering wheel
controls (SWC), such as programming the "Seek Up" function to be assigned to the "Mute"
button. Before beginning remapping:
• The GMOS-100 must have detected the vehicle and radio. That it recognizes that
it is attached before the remapping of any buttons.
• You can only start the remapping of the steering wheel controls process after the
ignition has been on for 20 seconds.
• After 20 seconds of turning the ignition on press and hold down the
"Volume Up" button for at least 25 seconds.
• Note, if during the remapping process no button is pushed for 30 seconds the
remapping process is aborted and it will revert to the original settings.
Now let's begin the remapping process:
1.
Ideally have the GMOS-100 visible so you can see the LED flashes. It is recommended
for visual confirmation of button recognition/programming.
2.
Turning off the radio is recommended.
3.
After 20 seconds of turning the ignition on press and hold down the
"Volume Up" button for at least 25 seconds.
4.
The LED will light up solid red. Release "Volume Up" and the LED will go out.
"Volume Up" has now been programmed.
Continued on next page
GMLAN11-100
Programming SWC
8