Advertisement
3. Battery charging
T7 will be partially charged when you first unpack it.
To charge T7 follow the steps described below.
• Select the appropriate regional plug adapter
for the mains outlet socket in your territory and
clip it to the power supply body as illustrated in
Diagram 2.
• Plug the T7 power supply into a mains outlet
socket and connect its output cable to T7 power
input socket. This is illustrated in Diagram 3. If
the mains outlet socket incorporates an isolator,
switch it on.
Once T7 is connected to power, its battery will begin
to charge. A full charge from a fully discharged state
will take approximately 4 hours. It is best initially to
leave T7 connected until it is fully charged although it
can be used while it is charging.
When the Power button is briefly pressed and
released the column of five indicators on the right-
hand side of T7 will illuminate for short period to
indicate the state of battery charge. The indicator
illumination depends on the level of charge as shown
in diagram 4.
Note: You can charge T7 at anytime independent
of battery level.
4. Switching on and off
To switch T7 on or off press and hold the Power
button for 2 seconds. T7 will provide audible
feedback as it switches on.
Note: If T7 is unused for more than 10 minutes it
will automatically enter sleep mode. Wake T7 by
starting a Bluetooth audio stream from a paired
device. T7 will also wake from sleep mode if
either the Bluetooth or power button is pressed.
If T7 is unused for more than 20 minutes it will
switch off automatically.
If T7 has not been previously used or it is not
within range of previously connected Bluetooth
devices when first switched on, only its auxiliary
input will be operational. See the following section
of this manual for information on connecting to
Bluetooth devices.
Diagram 2
Selecting the appropriate adapter
Diagram 3
Connecting T7 into the mains outlet
100%
80%
60%
40%
20%
Diagram 4
Battery life indicator
4
Advertisement
