1. Line up front (label and switch side) of
the power head with the Vac port
located on the front of the drum.
NOTE: Power head must be aligned with
drum for proper attachment.
2. Place power head on top of drum.
3. Be sure power head completely covers
the top of the drum so leakage does
4. Push down the flexible latches, and the
power head will attach to the drum.
5. To remove the power head, pull up on
the latches and remove from drum.
Insert the hose locking end of the
hose into the inlet of the
Vac. The hose should snap into place.
To remove the hose from the Vac, press
the release button in the hose assembly
and pull the hose out of the Vac inlet,
Your Wet/Dry Vac accessories can be
stored in the tool caddy mounted on the
The hose may be stored by wrapping it
around the unit and snapping it into the
recessed sides. The extension wands
can be stored underneath the Vac by
sliding the tapered end first through the
allotted hole on the back of the caddy.
The wand stop on the front of the Vac
will hold the extension wands in place.
Locking End of