Table of Contents
Advertisement
Operation
pull the gear change hand lever (1) to the position required.
3. Shutting down: when the operation is completed, turn off the power switch (5) first, then pull the gear
change hand lever (1) to position 1, and lower bowl to load position (6), and finally disconnect the power
supply.
NOTES
•
The power socket must be provided with a good ground wire to guarantee the mixer is grounded properly.
There will be an electric shock if there is no ground wire or if it is improperly mounted. Never connect the
ground wire to gas pipes, water pipes, lightning rods or telephone lines. Electric leakage should be checked
after installation. If the power line is damaged, it must be replaced by the a Service Company.
•
Do not put your hand into the stirring barrel during operation. Disconnect the power supply before the
installation of the mixer.
•
Do not operate the mixer beyond the time limit to prevent reduction of its service life.
•
The mixer should be mounted on a stable and clean place, keep it away from heat sources and wet places,
and away from equipment with strong electromagnetic properties.
•
Keep the machine clean constantly. Disconnect power supply before maintenance. Clean machine with a
soft damp cloth. Do not clean it with water spray or use harsh detergents.
On/Off Switch - MX-CN-0010-G
Features:
1. Standard Controls
On/Off Switch - MX-CN-0020-T
Features:
1. On Button
2. Off Button
3. Countdown Timer Knob
1
3
1
2
8
Advertisement
Table of Contents
