Installation - Omcan MX-CN-0020-G Instruction Manual

Installation

UNCRATING
Immediately after uncrating the mixer, check for possible shipping damage. If the machine is found to be
damaged after uncrating, save all packaging materials and contact the carrier within 3 days of delivery. Failure
to contact the carrier or supplier in a timely fashion may cause you a loss.
LOCATION
Prior to installation, test the electrical service to assure that it agrees with the specifications on the machine's
rating plate. Place the mixer on a sturdy and level surface. There should be adequate space around the mixer
for the user to operate the controls and to install and remove the bowls. Holes are located in the base to
permanently secure the mixer, although this is not necessary in normal installations.
ELECTRICAL CONNECTIONS
The electrical cords on these machines are equipped with a three-pronged grounding plug, which must be
connected to a properly grounded receptacle. If the receptacle is not properly grounded, contact an electrician.
DO NOT remove the grounding prong from the plug. Electrical and grounding connections must comply with
the applicable regulations and local electrical codes.
Check Initial Operation
1. Install the bowl and raise into the mix position, with the bowl support up and bowl safety guard closed.
2. Apply power to the mixer by inserting the cord plug into a properly grounded outlet.
3. Turn the Speed Lever to position 1.
4. Run the machine by pushing the START and then the STOP buttons.
Operation
WARNING
Moving agitator in bowl. Keep hands, clothing and utensils out of bowl while in operation. Do not use
without interlocked safety guard.
WARNING: DO NOT SWITCH GEARS DURING USAGE.
The Omcan mixers are equipped with Standard Safety features. Refer to the diagram on page 3 for an
explanation of their functions. The bowl safety guard must be in the closed position or the mixer will not
operate. The bowl must be raised and remain in mixing position on bowl support or the mixer will not operate.
1. Standard power supply 110V / 60Hz AC. (Please use a plug with 3 wide contacts and good grounding.)
2. Speed transformation: if you want to change the speed, please turn off the power switch (5) first, and then
7