Pentair HAFFMANS ICC Instruction Manual page 22

6. Reading equilibrium pressure, temperature and CO
Method:
1. Press the 'START' key one time to start the measurement,
From this point there are two possibilities:
1a Carefully push the temperature sensor down,
2a Shake the ICC-2000 several times until equilibrium pressure is reached and wait until the
measurement value on the screen stops increasing,
3a Equilibrium pressure has now been reached and the measured temperature as well as
the CO content calculated can be read,
2
4a Press the 'START' key (the values are saved). The CO
automatically using the Haffmans CO
1b Navigate the cursor with the arrow buttons until you reach pressure,
2b Push 'START', the pressure will be locked in the software,
3b Carefully push the temperature sensor down
4b Press the 'START' key (the values are saved). The CO
automatically using the Haffmans CO
7. Removing the bottle or can from the ICC-2000.
After measuring the CO
the following actions:
Attention!
Method:
1. Open the needle valve (pos. 13) so that the equilibrium pressure is released,
2. Pull the temperature sensor up,
3. Move the handle (pos. 46) back completely,
4. Close the needle valve again for the next measurement.
ICC
, the bottle or can must be removed from the ICC-2000 by carrying out
2
Carefully pull the temperature sensor (pos. 05) up until the sensor
is completely out of the bottle.
2
content is calculated
2
formula.
2
content is calculated
2
formula.
2
HAFFMANS ICC
content.
Page 21 of 49